Rear Side Door Hinge Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Side Door Hinge & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . IMPORTANT: Replace only one hinge at a time. Preliminary Procedure: Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
1	Rear Side Door Hinge Upper Bolts (Qty: 2) NOTE: Fastener Notice . Tighten: 25 N.m (18 lb ft)
2	Rear Side Door Hinge Upper Bolts (Qty: 2) Tighten: 25 N.m (18 lb ft)
3	Rear Side Door Upper Hinge Tip: Check the door for proper alignment, then adjust as necessary.
4	Rear Side Door Hinge Lower Bolt Tighten: 25 N.m (18 lb ft) Tip: After installation of the replacement upper hinge, from the underside of the hinge, remove the temporary keeper pivot bolt and replace with longer permanent bolt.
5	Rear Side Door Hinge Lower Bolts (Qty: 2) Tighten: 25 N.m (18 lb ft)
6	Rear Side Door Hinge Lower Bolts (Qty: 2) Tighten: 25 N.m (18 lb ft)
7	Rear Side Door Lower Hinge Tip: Check the door for proper alignment, then adjust as necessary.