LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 86 (Bolted Exterior Body Panels And Closures) >> Repair Instructions >> Hood Latch Release Handle Replacement

Hood Latch Release Handle Replacement

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Hood Latch Release Cable & Nut
GM1674991Courtesy of GENERAL MOTORS CORP.
Hood Latch Release Handle Replacement

Callout Component Name
NOTE: Refer to Fastener Notice .
Fastener Tightening Specifications:  Refer to Fastener Tightening Specifications .Preliminary Procedure: Remove the front lower hinge pillar trim. Refer to Garnish Molding Replacement - Center Pillar Lower .
1 Hood Latch Release Cable Nut

Tighten:  9 N.m (80 lb in)
2 Hood Latch Release Cable
scientia non olet · About LEMON Manuals