Roof Panel Joint Finish Molding Replacement (Tahoe)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Roof Panel Joint Finish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Roof Panel Joint Finish Molding (Roof Outer Panel) Tip: The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Remove the roof panel finish joint from the roof ditch. Use of a heat gun is recommended. Using a 50/50 mixture of isopropyl alcohol, clean drinkable water and a clean towel, remove the left over adhesive residue from the ditch. Wipe the roof ditch clean with a clean dry towel. Peel the adhesive tape backing from the roof panel joint finish molding. Secure the molding starting at the rear of the front door edge working rearward. Completely wet out the roof panel finish joint molding using the hand and a clean dry towel.

Callout

Component Name

Roof Panel Joint Finish Molding (Roof Outer Panel)
Tip:

The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
Remove the roof panel finish joint from the roof ditch.
Use of a heat gun is recommended.
Using a 50/50 mixture of isopropyl alcohol, clean drinkable water and a clean towel, remove the left over adhesive residue from the ditch.
Wipe the roof ditch clean with a clean dry towel.
Peel the adhesive tape backing from the roof panel joint finish molding.
Secure the molding starting at the rear of the front door edge working rearward.
Completely wet out the roof panel finish joint molding using the hand and a clean dry towel.