LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Liftgate Upper >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean any remaining adhesive from the window surface using VMP naptha.
  2. Wipe the surface with a clean cloth to removal all traces of cleaner.
  3. Ensure that the surface of the liftgate in the tape contact area is clean and dry.
  4. Using a clean dauber, apply adhesion promoter to the window surface where the adhesive strip will contact.
  5. Peel the backing from the adhesive on the liftgate applique.
  6. Fig 1: Liftgate Applique & Liftgate Window
    GM1397277Courtesy of GENERAL MOTORS CORP.
  7. Lower the front edge of the liftgate applique (1) against the liftgate (2) surface approximately 2 mm (0.08 in) above the liftgate offset.
  8. IMPORTANT: Do not let the tape surface contact the liftgate surface until after the part rotation.
  9. Rotate the liftgate applique (1) down over the top of the liftgate window (2).
  10. Press the liftgate applique (1) to the liftgate window (2).
  11. Hand roll the liftgate applique to the liftgate window in order to ensure proper adhesion.
  12. Install the high mounted stop lamp.
  13. Open the liftgate window.
  14. Fig 2: Liftgate Applique Fastener & Window Frame
    GM1397212Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  15. Tighten the fasteners (1) securing the liftgate applique to the liftgate window frame (2) on the left and right side.

    Tighten:  Tighten the bolt to 5 N.m (44 lb in).

  16. Install the fasteners retaining the high mounted stop lamp. Refer to High Mounted Stop Lamp Replacement (Yukon) or High Mounted Stop Lamp Replacement (Escalade) or High Mounted Stop Lamp Replacement (Avalanche) .
  17. Close the liftgate window.