LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Door Lower (Tahoe/GMC) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower Door Molding (Tahoe/Yukon)
    GM590177Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not scratch or chip the paint.
  1. Heat the bodyside molding using a heat gun. Hold the heat gun approximately 152 mm (6 in) from the surface.

    Apply heat using a circular motion for about 30 seconds.

  2. Starting from one end of the molding, remove the molding from the panel surface using a flat-bladed tool.
  3. Remove all of the adhesive from the body panel using a 3M™ Scotch Brite molding adhesive remover disc, P/N 07501, or equivalent.
scientia non olet · About LEMON Manuals