Hood Front Molding Replacement (Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Hood Front Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Open the hood in order to access the front hood molding and retainers.
1	Hood Front Molding Tip: The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength. Release the 7 integral retainers from the hood. Upon installation, align the left hand center retainer first into the hood. Gently secure the remaining retainers working from left to right across the entire hood molding.

Callout

Component Name

Preliminary Procedure:
Open the hood in order to access the front hood molding and retainers.

Hood Front Molding
Tip:

The part and surface should be 21°C (70°F) prior to installation. The vehicle should remain 21°C (70°F) for one hour after assembly to allow adhesive to develop sufficient bond strength.
Release the 7 integral retainers from the hood.
Upon installation, align the left hand center retainer first into the hood.
Gently secure the remaining retainers working from left to right across the entire hood molding.