Front Fog Lamp Replacement (Escalade)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Fog Lamp Assembly & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the front lower bumper filler. Refer to Bumper Filler Replacement - Front Side (All Utility, Avalanche, Cadillac EXT) or Bumper Filler Replacement - Front Side (Z71) . Disconnect the electrical connectors for the front park turn signal lamp and the front fog lamp sockets. The bulbs can be removed after the lamp housing has been removed from the front bumper fascia.
1	Nuts (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 10 N.m (89 lb in)
2	Front Fog Lamp Assembly Tip: Remove the lamp assembly from the front side of the lower bumper fascia.
3	Fog Lamp Bulb CAUTION: Refer to Halogen Bulb Caution . Tip: Rotate the bulb socket counterclockwise in order to remove.
4	Park, Turn Signal Lamp Bulb Socket Tip: Rotate the bulb socket counterclockwise in order to remove.
5	Park, Turn Signal Lamp Bulb Tip: Pull the bulb straight from the socket.