Driving with IntelliBeam: Notes
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
IntelliBeam will only activate the high-beams when driving over 32 km/h (20 mph). The high beam headlamps will remain ON, under the automatic control of IntelliBeam, until any of the following situations occur:
- The system detects an approaching vehicles headlamps.
- The system detects a preceding vehicles tail lamps.
- The outside light is bright enough that the high-beam headlamps are not required.
- The vehicles speed drops below 24 km/h (15 mph).
- The headlamp stalk is moved forward to the high-beam position or the flash-to-pass feature issued. See when either of these conditions occur, the IntelliBeam feature will be disabled and the IntelliBeam light in the mirror will turn OFF until the high-beam stalk is returned to the neutral position.
- If IntelliBeam was using low-beams prior to this action, the IntelliBeam feature will be temporarily disabled until the stalk is returned to the neutral position.
- The exterior lamp control is turned to any setting except AUTO. When this occurs, IntelliBeam will be disabled until the control is turned back to the AUTO position.
- The IntelliBeam system is turned OFF at the inside rearview mirror.
The high beam headlamps may need to manually disabled or canceled by turning the low beam headlamps ON, if any of the above conditions exist.