Garnish Molding Replacement - Sunroof Panel Window (Extended)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Garnish Molding

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Sunroof Panel/Window Garnish Molding Assembly Tip: Tilt molding approximately 45 degrees with rear end up. Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs. Grab front of molding at centerline and pull rearward approximately 1 inch. Push front edge up, locking front tabs in place. Push up on outboard edges of molding to secure. After molding is secured, slide the molding forward until it stops.

Callout

Component Name

Sunroof Panel/Window Garnish Molding Assembly
Tip:

Tilt molding approximately 45 degrees with rear end up.
Push molding rearward to sandwich headliner and sunroof tub between molding flange and tabs.
Grab front of molding at centerline and pull rearward approximately 1 inch.
Push front edge up, locking front tabs in place.
Push up on outboard edges of molding to secure.
After molding is secured, slide the molding forward until it stops.