LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Lighting) >> Repair Instructions >> Tail Lamp Guard Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Tubular Tail Lamp Guard
    GM855708Courtesy of GENERAL MOTORS CORP.
  1. Position the tail lamp guard to the vehicle.
    2. Fig 2: Tubular Tail Lamp Guard Screws
    GM855707Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the screws retaining the tail lamp guard.

    Tighten:  Tighten to 6 N.m (53 lb in).

  3. Clean the surface where the adhesive strip will mount with varnish and makers (VMP) naptha.
    4. Fig 3: Adhesive Strip To Body
    GM855709Courtesy of GENERAL MOTORS CORP.
  4. Carefully align adhesive strip to body and pull exposed tape lead down.
  5. Apply approximately 30 psi to tail lamp guard to adhere guard to the body.
  6. Close the liftgate.
scientia non olet · About LEMON Manuals