LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Lighting) >> Repair Instructions >> Rear Side Marker Lamp Replacement (SUT Left) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Lamp Connector
    GM1453846Courtesy of GENERAL MOTORS CORP.
  1. Position the harness through the body panel opening (3).
  2. Connect the electrical connector (4) to the main body harness (2).
  3. Ensure the electrical connection is secure to the inside body panel (1).
    4. Fig 2: Rear Side Marker Lamp (SUV)
    GM803115Courtesy of GENERAL MOTORS CORP.
  4. Position the lamp housing to the outer body panel.
    5. NOTE: Refer to Fastener Notice .
  5. Install the screws with foam washers.

    Tighten:  Tighten the screws to 3 N.m (26 lb in).

    6. Fig 3: LH Rear Compartment Side Trim Panel
    GM1412540Courtesy of GENERAL MOTORS CORP.
  6. Install the LH rear compartment side trim panel (1). Refer to Rear Compartment Side Trim Replacement - Left Side .
scientia non olet · About LEMON Manuals