Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Install the bulb.

Fig 1: Locating Retaining Nuts & Connecting Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Install the bulb socket (6) by turning the socket clockwise.
Install the lamp.
Open the hood.

NOTE: Refer to Fastener Notice .

Install the retaining nuts (2).
Tighten: Tighten the nuts to 6 N.m (53 lb in).
Connect the electrical harness.
Close the hood.
Install the grille. Refer to Grille Replacement .