Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Position Lamp Housing To End Cap

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Ensure the bottom edge is secured first.

Position the lamp housing to the end cap opening.
Press inward at the top of the lamp in order to secure the tab (3).

Fig 2: Removing/Installing Lamp Bulb

Courtesy of GENERAL MOTORS CORP.

Position the lamp socket (1) into the lamp (2) and turn 1/4 in order to secure.