Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lamp Socket Assembly

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Fasten the new lamp socket to the overhead console.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 2: Connecting Individual Connectors To Garage Door Module

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors to the reading lamp.

Fig 3: Fastening Overhead Console To Headliner

Courtesy of GENERAL MOTORS CORP.

Attach the overhead console to the headliner.
Tighten: Tighten the screws to 2 N.m (18 lb in).

Fig 4: Reading Lamp Lens

Courtesy of GENERAL MOTORS CORP.

Install the new bulb assembly to the overhead console.
Snap the lens for the reading lamp into place in the overhead console.