LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Lighting) >> Repair Instructions >> Identification Lamp Replacement (SUV) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identification Lamp Retaining Clip (SUV)
    GM803119Courtesy of GENERAL MOTORS CORP.
  1. Insert a flat-bladed tool underneath the lamp on the notched side, to disengage the retaining clip.
    2. Fig 2: Identification Lamp Assembly (SUV)
    GM803120Courtesy of GENERAL MOTORS CORP.
  2. Tilt the lamp back to disengage the hook.
  3. Remove the electrical harness at the connector.
  4. Remove the lamp from the vehicle.
  5. Turn the bulb socket counterclockwise to remove the bulb from the lamp assembly.
  6. Remove the bulb from the socket.
scientia non olet · About LEMON Manuals