Removal Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Protect the surface with 2 layers of masking tape.
- Insert a flat-bladed tool underneath the lamp on the outer edge to disengage the retention clip.
- Tilt the lamp rearward in order to disengage the lamp from the front header.
- Disconnect the electrical connector.
- Remove the lamp from the vehicle.
- Turn the bulb socket counterclockwise in order to remove the socket from the lamp assembly.
- Remove the bulb from the socket, if needed.