Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the lamp, with the attached harness, to the vehicle.
- Install the grommet to the liftgate.
- Install the retaining screws.
Tighten: Tighten the screws to 3 N.m (26 lb in).
- Connect the electrical connector to the high mounted stop lamp.
- Install the liftgate trim panel. Refer to Liftgate Trim Panel Replacement .
NOTE:
Refer to Fastener Notice
.