Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing CHMSL Assembly

Courtesy of GENERAL MOTORS CORP.

Install a new foam gasket.
Install the lamp, with the attached harness, to the rear header.
Secure the electrical harness grommet to the rear header.

NOTE: Refer to Fastener Notice .

Install the retaining screws.
Tighten: Tighten the screws to 3 N.m (26 lb in).
Connect the electrical connector for the CHMSL to the headliner harness.
Re-secure the rear of the headliner.