LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Lighting) >> Repair Instructions >> Hazard and Turn Signal Flasher Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Hazard & Turn Signal Flasher
    GM786886Courtesy of GENERAL MOTORS CORP.
  1. Remove the knee bolster trim panel. Refer to Driver Knee Bolster Panel Replacement .
  2. On the back side of the fuse block release the retainer while pulling the flasher (1) inboard.
  3. Remove the flasher (1) from the fuse block.
scientia non olet · About LEMON Manuals