LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Lighting) >> Repair Instructions >> Hazard and Turn Signal Flasher Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Hazard & Turn Signal Flasher
    GM786886Courtesy of GENERAL MOTORS CORP.
  1. Install the flasher (1) to the fuse block until the retainer clicks into place.
  2. Install the knee bolster. Refer to Driver Knee Bolster Panel Replacement .
scientia non olet · About LEMON Manuals