LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Lighting) >> Diagnostic Information and Procedures >> Daytime Running Lamps (DRL) Always On

Daytime Running Lamps (DRL) Always On

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Daytime Running Lamps (DRL) Always On

Step Action Yes No
Schematic Reference: Headlights/Daytime Running Lights (DRL) Schematics 
Connector End View Reference: Lighting Systems Connector End Views  or Data Communication Connector End Views
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Ensure the park brake is released.
  2. Turn ON the ignition, with the engine OFF.
  3. With the brake pedal depressed, place the gear selector in any drive gear.
  4. Place the headlamps in the ON position.
Does the system operate normally?		 Go to Testing for Electrical Intermittents Go to Step 3 
3
  1. Place the headlamps in the AUTO position.
  2. Disconnect the daytime running lamp (DRL) relay.
Do the DRL turn OFF?		 Go to Step 4  Go to Step 7 
4
  1. Reconnect the DRL relay.
  2. Use the scan tool to observe the DRL parameter and command the DRL ON and OFF several times.
Does the DRL parameter change states as expected?		 Go to Step 5  Go to Step 6 
5 Inspect for poor connections at the harness connector of the DRL relay. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?		 Go to Step 10  Go to Step 8 
6 Inspect for poor connections at the harness connector of the body control module (BCM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?		 Go to Step 10  Go to Step 9 
7 Repair the DRL supply voltage circuit. Refer to Wiring Repairs .
Did you complete the repair?		 Go to Step 10  -
8 Replace the DRL relay. Refer to Relay Replacement (Attached to Wire Harness) or Relay Replacement (Within an Electrical Center) .
Did you complete the replacement?		 Go to Step 10  -
9 Replace the BCM. Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 10  -
10 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals