LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B0016 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector.
    • The roof rail module - left
    • The SDM module
    • The roof rail module - left wiring harness connector
    • The SDM wiring harness connector
  1. Ignition OFF, remove the center pillar trim and disconnect the roof rail module - left connector. Refer to Garnish Molding Replacement - Center Pillar Upper .
  2. Connect the J 38715-A  to the harness side of the roof rail module - left connector. See Special Tools . Use the PASSENGER INFLATOR connector located on the load tool.
  3. Ignition ON, use a scan tool to observe the SIR DTC display. Verify DTC B0016 is set in history.
    • If DTC B0016 is history replace the roof rail module - left.
  4. Ignition OFF, disconnect and remove the J 38715-A  . See Special Tools . Then remove the SDM connector. Refer to SDM replacement  in Repair Instructions for connector location.
  5. Test the high and low circuits between the SDM and roof rail module - left for a short to voltage, short to ground, or open/low resistance. Verify that a short to voltage, short to ground, or open/low resistance does not exist.
    • If any of the above conditions are found make the appropriate repair.
  6. If circuits test good then replace the SDM.
scientia non olet · About LEMON Manuals