Garnish Molding Replacement - Windshield Pillar

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Windshield Side Garnish Molding Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Disable roof rail SIR system. Refer to SIR Disabling and Enabling . Remove front assist handle (passenger side only). Refer to Assist Handle Replacement - Front .
1	Windshield Side Garnish Molding Cover
2	Windshield Side Garnish Molding Screw NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
3	Windshield Side Garnish Molding Assembly Tip: Tabs must be installed prior to retainers. Tabs to be fully seated in I/P trim panel retainer and valance panel. Disconnect electrical connectors.
4	Windshield Side Garnish Molding Retainer (Qty: 2)