Rear Seat Riser Finish Cover Replacement (Tahoe/Yukon/Escalade w/Split Bench)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Seat Riser Finish Covers & Screws

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Flip and fold the rear seat forward. Remove the rear seat floor filler trim cover.
1	Rear Seat Riser Finish Cover Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Rear Seat Riser Finish Cover (Qty: 2)
3	Rear Seat Riser Finish Cover (Qty: 2)