Floor Carpet Drying
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
If the carpet or the pad or insulator is wet, use the following criteria for drying or for replacing the components:
- For a 1-piece carpet assembly bonded to a cotton or a fiber padding, replace the entire assembly.
- For a 2-piece carpet assembly with a cotton or a fiber padding, replace the padding only. While the carpet is out of the vehicle, dry the carpet using the method described below.
- For a 1-piece carpet assembly bonded to a foam padding or attached to a synthetic padding, dry the carpet using the method described below.
- For a 2-piece carpet assembly with a synthetic padding, dry the assembly using the method described below.
Drying Method
- If you observe puddles of liquid on the carpet face, use a wet vacuum to remove the excess moisture.
- Blot the face of the carpet with a towel in order to absorb as much moisture as possible.
- Point a fan at the affected area and air dry the carpet.