LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Steering Linkage) >> Repair Instructions >> Tie Rod Replacement - Inner >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/ Installing Inner Tie Rods Ends
    GM865341Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .
  3. Remove the steering linkage outer tie rod ends. Refer to Tie Rod Replacement - Outer .
  4. Remove the inner tie rod ends using the J 34028  (2). See Special Tools .
scientia non olet · About LEMON Manuals