LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Steering Linkage) >> Repair Instructions >> Tie Rod Replacement - Inner >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/ Installing Inner Tie Rods Ends
    GM865341Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: Perform the following procedure before installing the new tie rod ends.
    • Remove all traces of the oil, grease, or other contaminants.
    • Clean the threads of the tie rod with denatured alcohol or the equivalent and allow to dry.
    • Apply Threadlocker GM P/N 12345493 or Canadian P/N 10953488 to the threads of the tie rod.
  1. Install the steering gear inner tie rod to the relay rod.

    Tighten:  Using the J 34028  (2) tighten the tie rod to 100 N. See Special Tools .m (74 lb ft).

  2. Install the steering linkage outer tie rods. Refer to Tie Rod Replacement - Outer .
  3. Install the engine protection shield. Refer to Engine Protection Shield Replacement .
  4. Adjust the front toe. Refer to Front Toe Adjustment .
scientia non olet · About LEMON Manuals