Right Side Steering Linkage

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Elevated Right Front Of Vehicle

Courtesy of GENERAL MOTORS CORP.

Elevate the right front of vehicle and install a suitable vehicle support, maintaining contact between the left front wheel shop floor.

Fig 2: Installing A Dial Indicator Between The Outer Tie Rod And Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

Install a dial indicator between the outer tie rod and steering knuckle as shown and push inward to remove the lash slowly with one hand.

Fig 3: Noting Amount Of Movement In Right Side Joint

Courtesy of GENERAL MOTORS CORP.

Place the dial indicator at zero, pull outward and note amount of movement in joint.
Movement should not exceed 1.0 mm (0.039 in).

Fig 4: Installing The Dial Indicator Between The Outer Tie Rod End And Relay Rod

Courtesy of GENERAL MOTORS CORP.

Install the dial indicator between the outer tie rod end and relay rod as shown and push inward to remove the lash slowly with one hand.

Fig 5: Noting Amount Of Movement In Right Side Tie Rod End

Courtesy of GENERAL MOTORS CORP.

Place the dial indicator at zero, pull outward and note amount of movement in the joint.
Movement should not exceed 1.0 mm (0.039 in).