LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (1 Of 2)) >> Scan Tool Data List

Scan Tool Data List

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Use the scan tool data list under the following conditions:

The values below represent a typical display recorded from a properly functioning system.

IMPORTANT: Do not use a scan tool that displays faulty data. Report the condition to the scan tool manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.

Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.

Scan tool values below were recorded under the following conditions:

Transmission Scan Tool Data List

Scan Tool Parameter Data List* Units Displayed Typical Data Value
1-2 Shift Error F2, F7/F0 Seconds Varies
1-2 Shift Time F0, F2, F7/F0 Seconds Varies
1-2 Sol. F0, F2, F3, F4 On/Off On
1-2 Sol. Open/Short to GND F2 Yes/No No
1-2 Sol. Short to Volts F2 Yes/No No
1-2 TAP Cell (4-16) F7/F0 kPa (Psi) Varies
2-3 Shift Error F3, F7/F1 Seconds Varies
2-3 Shift Time F0, F3, F7/F1 Seconds Varies
2-3 Sol. F0, F2, F3, F4 On/Off On
2-3 Sol. Open/Short to GND F3 Yes/No No
2-3 Sol. Short to Volts F3 Yes/No No
2-3 TAP Cell (4-16) F7/F1 kPa (Psi) Varies
3-2 Downshift Sol. F0, F5 On/Off Off
3-2 Sol. Open/Short to GND F5 Yes/No No
3-2 Sol. Short to Volts F5 Yes/No No
3-4 Shift Error F4 Seconds Varies
3-4 Shift Time F0, F4 Seconds Varies
4WD F0 Enabled/Disabled Disabled
4WD Low F0 Enabled/Disabled Disabled
A/C Clutch F0 On/Off Off
Commanded Gear F0, F1, F2, F3, F4, F5, F6 1, 2, 3, 4 1
Cruise F0 Enabled/Disabled Disabled
Current TAP Cell F7/F0, F7/F1 4-16 Varies
ECT F0, F1 °C (°F) Varies
Engine Run Time F0 Hr/Min/Sec Varies
Engine Speed F0, F1, F2, F3, F4, F5, F6 RPM Varies
Engine Torque F0, F1 N.m (lb ft) Varies
Estimated Gear Ratio F0, F1, F2, F3, F4 Ratio 8.00:1
Ignition Voltage F0 Volts 12-14 Volts
Last Shift Time F0 Seconds Varies
PC Sol. Actual Current F0, F6 Amps Varies, 0.1-1.1 amps
PC Sol. Duty Cycle F0, F6 Percent Varies
PC Sol. Ref. Current F0, F6 Amps Varies, 0.1-1.1 amps
Power Take Off F0 No/Yes No
Speed Ratio F0, F1, F2, F3, F4, F5 Ratio 8.00:1
TCC Brake Switch F0, F1 Open/Closed Closed
TCC Duty Cycle F0, F1 Percent 0%
TCC Duty Cycle Open/Short to GND F1 Yes/No No
TCC Duty Cycle Short to Volts F1 Yes/No No
TCC Enable F0, F1 Yes/No No
TCC Enable Open/Short to GND F1 Yes/No No
TCC Enable Short to Volts F1 Yes/No No
TCC Slip Speed F0, F1 RPM +/-50 RPM from Engine Speed
TFP Sw. F0 Park/Neutral, Reverse, Drive4, Drive3, Drive2, Drive1 or Invalid Park/Neutral
TFP Sw. A/B/C F0 HI/LOW HI/LOW/HI
TFT Sensor F0, F1, F6 Volts Varies
Torque Converter Efficiency F0, F1, F2, F3, F4 Ratio .00:1
Tow/Haul Mode F0 Active/Inactive Inactive
TP Indicated Angle F0, F1, F2, F3, F4, F5, F6 Percent Varies
TR Sw. F0 Park, Reverse, Drive4, Drive3, Drive2, Drive1 or Invalid Park
TR Sw. A/B/C/P F0 HI/LOW LOW/HI/HI/LOW
Traction Control F0 Active/Inactive Inactive
Trans. Fluid Temp. F0, F1, F5, F6 °C (°F) Varies
Trans. Slip Counter F0, F1 0, 1, 2 0
Transfer Case Ratio F0, F2, F3, F4 Ratio 2.61:1
Transmission Hot Mode F0, F1 On/Off Off
Transmission OSS F0, F1, F2, F3, F4, F5 RPM 0
Vehicle Speed F0, F1, F2, F3, F4, F5 km/h (mph) 0

*Data List Legend

  • F0: Transmission Data
  • F1: TCC Data
  • F2: 1-2 Shift Data
  • F3: 2-3 Shift Data
  • F4: 3-4 Shift Data
  • F5: 3-2 DownShift Data
  • F6: PC Solenoid Data
  • F7: Transmission Adapts
  • F7/F0: 1-2 Adapt. Data
  • F7/F1: 2-3 Adapt. Data