LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Tires And Wheels) >> Repair Instructions >> Spare Tire Carrier Replacement >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The following components of the spare tire carrier can be replaced, license plate lamp harness, carrier swing arm, hinge, striker/sleeve, and latch mechanism and housing. Refer to the following information for the disassembly of the spare tire carrier. These components can either be disassembled on the vehicle or on a work bench.
    Fig 1: License Plate Lamp Screws
    GM1504075Courtesy of GENERAL MOTORS CORP.
  1. Remove the license plate lamp screws.
    2. Fig 2: License Plate Lamp Harness
    GM1504078Courtesy of GENERAL MOTORS CORP.
  2. Remove the license plate lamp harness from the clips on the carrier.
  3. Remove the harness.
    4. Fig 3: Spare Tire Carrier Swing Arm
    GM1504080Courtesy of GENERAL MOTORS CORP.
  4. Remove the spare tire carrier swing arm from the hinge.
    5. Fig 4: Striker Bolt And Sleeve
    GM1504082Courtesy of GENERAL MOTORS CORP.
  5. Remove the striker bolt and sleeve.
    6. Fig 5: Latch Mechanism & Related Components
    GM1504086Courtesy of GENERAL MOTORS CORP.
  6. Remove the latch mechanism bolts, nuts, and spacers.
  7. Remove the latch mechanism.
  8. Remove the latch mechanism isolator bolts.
  9. Remove the latch mechanism isolator.
scientia non olet · About LEMON Manuals