LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Rear Suspension) >> Repair Instructions >> Wheel Stud Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  3. Remove the rotor. Refer to Rear Brake Rotor Replacement .
    4. Fig 1: Removing Wheel Stud From Axle Flange
    GM649304Courtesy of GENERAL MOTORS CORP.
  4. Remove the axle shaft. Refer to Rear Axle Shaft Replacement .
  5. Remove the wheel stud from the axle flange using the J 43631  .
scientia non olet · About LEMON Manuals