LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Rear Suspension) >> Repair Instructions >> Stabilizer Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the rear axle at curb height.
    3. Fig 1: Stabilizer Shaft Link
    GM793283Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft link nut from the ball stud.
    4. Fig 2: Stabilizer Shaft
    GM793284Courtesy of GENERAL MOTORS CORP.
  4. Remove the stabilizer shaft insulator bracket mounting bolts.
  5. Remove the stabilizer shaft.
  6. Remove the stabilizer shaft insulators brackets.
  7. Remove the stabilizer shaft insulators.
scientia non olet · About LEMON Manuals