LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Rear Suspension) >> Repair Instructions >> Stabilizer Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Stabilizer Shaft
    GM793284Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulators to the stabilizer shaft.
  2. Install the stabilizer shaft.
  3. Install the stabilizer shaft insulator brackets to the rear axle.
  4. Install the stabilizer shaft bracket mounting bolts.
    5. Fig 2: Stabilizer Shaft Bracket Mounting Bolts (15/25 Series)
    GM613612Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
    IMPORTANT: When tightening the lower link nut verify that the inner jam nut bottoms out on the ball stud.
  5. Install the stabilizer shaft link nut to the ball stud.

    Tighten: 

    1. Tighten the ball stud to stabilizer shaft nut to 72 N.m (53 lb ft).
    2. Tighten the insulator bracket bolts to 33 N.m (24 lb ft).

  6. Remove the rear axle support.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals