LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Rear Suspension) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Support the rear axle at curb height.
    3. Fig 1: Stabilizer Shaft Link
    GM793283Courtesy of GENERAL MOTORS CORP.
  3. Remove the stabilizer shaft link nut and bolt from the frame bracket.
  4. Remove the stabilizer shaft link nut from the ball stud.
  5. Remove the stabilizer shaft link.
scientia non olet · About LEMON Manuals