LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Rear Suspension) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Stabilizer Shaft Link
    GM793283Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft link.
    2. IMPORTANT: When tightening the lower link nut verify that the inner jam nut bottoms out on the ball stud.
    Fig 2: Stabilizer Shaft Bracket Mounting Bolts (15/25 Series)
    GM613612Courtesy of GENERAL MOTORS CORP.
  2. Install the stabilizer shaft link nut to the ball stud.
    3. NOTE: Refer to Fastener Notice .
    Fig 3: Stabilizer Shaft Link
    GM793283Courtesy of GENERAL MOTORS CORP.
  3. Install the stabilizer shaft link nut and bolt to the frame bracket.

    Tighten: 

    1. Tighten the link to frame bracket nut to 72 N.m (53 lb ft).
    2. Tighten the ball stud to stabilizer shaft nut to 72 N.m (53 lb ft).

  4. Remove the rear axle support.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals