LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Rear Suspension) >> Repair Instructions >> Stabilizer Shaft Insulator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Stabilizer Shaft
    GM793284Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft insulators to the stabilizer shaft.
  2. Install the stabilizer shaft insulator brackets to the rear axle.
    3. NOTE: Refer to Fastener Notice .
  3. Install the stabilizer shaft bracket mounting bolts.

    Tighten:  Tighten the insulator bracket bolts to 33 N.m (24 lb ft).

  4. Remove the rear axle support.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals