LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Rear Suspension) >> Repair Instructions >> Rear Axle Upper Control Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the air suspension level sensor (if equipped). Refer to Air Spring Leveling Sensor Replacement .
  3. Support the rear axle at the ride height.
    4. Fig 1: Upper Control Arm Retaining Nut & Bolt (Frame Bracket)
    GM793292Courtesy of GENERAL MOTORS CORP.
  4. Remove the upper control arm retaining nut and bolt from the frame bracket.
    5. Fig 2: Upper Control Arm Retaining Nut & Bolt (Axle Bracket)
    GM793291Courtesy of GENERAL MOTORS CORP.
  5. Remove the upper control arm retaining nut and bolt from the axle bracket.
  6. Remove the upper control arm.
scientia non olet · About LEMON Manuals