Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Support the rear axle at curb height.

Fig 1: Track Bar Retaining Nuts & Bolts

Courtesy of GENERAL MOTORS CORP.

Disconnect the park brake cable from the track bar.
Remove the rear axle tie rod retaining nuts.
Remove the rear axle tie rod retaining bolts.
Remove the rear axle tie rod from the vehicle.