Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear axle tie rod to the vehicle.
- Install the rear axle tie rod retaining bolts.
- Install the rear axle tie rod retaining nuts.
Tighten: Tighten the bolts to 140 N.m (103 lb ft).
- Install the park brake cable to the track bar.
- Remove the rear axle support.
- Lower the vehicle.
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
Do not tighten the bolts unless the suspension is at the curb height position.