LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 68 (Rear Suspension) >> Repair Instructions >> Rear Axle Lower Control Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Control Arm
    GM793290Courtesy of GENERAL MOTORS CORP.
  1. Install the lower control arm.
    2. NOTE: Refer to Fastener Notice .
    IMPORTANT: Do not tighten the bolts unless the suspension is at the curb height position.
  2. Install the lower control arm to axle bolt and nut.

    Tighten:  Tighten the bolt to 275 N.m (203 lb ft).

    3. IMPORTANT: Do not tighten the bolts unless the suspension is at the curb height position.
  3. Install the lower control arm to frame bolt and nut.

    Tighten:  Tighten the bolt to 175 N.m (129 lb ft).

  4. Install the fuel tank shield. Refer to Fuel Tank Shield Replacement .
  5. Remove the rear axle support.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals