Sunroof Window Height and Opening Fit Adjustment
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- In order to adjust the glass height, the sunroof glass must be in the zero, closed, position.
- Loosen the 4 adjustment screws.
- Adjust the rear glass panel (1) so that it is flush with the roof panel (3), 0-2.0 mm (0.079 in) above 3.
Tighten: Tighten all 4 adjustment screws to 4 N.m (35 lb in).
- Adjust the front glass panel (2) so that it is flush with the roof panel (3), 0-1.0 mm (0.040 in) below 3.
Tighten: Tighten all 4 adjustment screws to 4 N.m (35 lb in).
IMPORTANT:
Do not remove the screws from the sunroof mechanism.
NOTE:
Refer to Fastener Notice
.