LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Sunroof) >> Repair Instructions >> Sunroof Module Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sunroof finishing lace. Refer to Sunroof Finishing Lace Replacement .
    2. Fig 1: Sunroof Module Assembly
    GM832111Courtesy of GENERAL MOTORS CORP.
  2. It is only necessary to lower the headliner. Only do those steps in headliner replacement that will lower the headlinder enough to gain access to the part. Refer to Headlining Trim Panel Replacement .
  3. Remove the sunroof motor. Refer to Power Sunroof Motor Replacement .
  4. Remove the sunroof sunshade. Refer to Sunroof Sunshade Replacement .
  5. Remove the sunroof glass panel. Refer to Sunroof Glass Panel Replacement .
  6. Disconnect the front drain hoses from the sunroof module. Refer to Sunroof Housing Front Drain Hose Replacement .
  7. Disconnect the rear drain hoses from the sunroof module. Refer to Sunroof Housing Rear Drain Hose Replacement (SUT)  or Sunroof Housing Rear Drain Hose Replacement (SUT) .
  8. Remove the retaining nuts from the sunroof module rear brackets.
  9. Remove the retaining bolts from the sunroof module.
  10. With the aid of an assistant, remove the sunroof module assembly from the vehicle.
  11. Remove the rear brackets from the sunroof module.
scientia non olet · About LEMON Manuals