Installation Procedure
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
- Start the joint aligned with the forward tab and hook and loop strip on the left side of the opening.
- Press the trim lace (2) into place onto the sunroof module flange (1) until fully seated around the sunroof opening.
- Pull the finish lace draw cord downward and remove the cord from the periphery of the opening.
- Ensure the finishing lace (2) is properly seated over the outer surface of the headliner (3).
IMPORTANT:
When installing the lace, ensure the corners are fully seated and no slack exists as you go around the opening.