Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Sunroof Motor/Actuator

Courtesy of GENERAL MOTORS CORP.

Synchronize the sunroof motor (3) and module assembly. Refer to Sunroof Track Timing/Synchronization .
Position the motor to the sunroof module.

NOTE: Refer to Fastener Notice .

Install the bolts (1) to the motor.
Tighten: Tighten the bolts to 6 N.m (53 lb in).
Verify proper operation of the sunroof.
Install the overhead roof console. Refer to Roof Console Replacement (Full Length) or Roof Console Replacement (Short Length) .