To Close
WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
To close the power sunroof from the:
- Open position-press and hold the sunroof switch forward. This will apply an input to the sunroof actuator motor from the sunroof switch close contacts through the sunroof switch close signal circuit. The sunroof switch close input at the sunroof actuator motor needs to be constant, switch pressed, allowing the sunroof actuator motor to control the motor to drive the sunroof window forward, until it reaches the closed position. To close the sunshade, this will have to be manually slid closed.
- Vent position-press and hold the sunroof switch rearward. This will apply an input to the sunroof actuator motor from the sunroof switch open contacts through the sunroof switch circuit. The sunroof switch open input to the sunroof actuator motor needs to be constant, switch pressed, to allow the motor to tilt the sunroof window down to the fully closed position.