LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to Fastener Notice .
  1. Install the sight shield retainer and the bolts, if required.

    Tighten:  Tighten the retainer bolts to 5 N.m (44 lb in).

    2. Fig 1: View Of Top Engine Cover
    GM665886Courtesy of GENERAL MOTORS CORP.
    NOTE: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector. Loss of engine performance or engine damage may result.
  2. Install the intake manifold sight shield to the retainer.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals