LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Pump, Screen, and Crankshaft Oil Deflector Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Screen & O-Ring Seal
    GM647800Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil pan. Refer to Oil Pan Replacement .
  2. Remove the engine front cover. Refer to Engine Front Cover Replacement .
  3. Remove the oil pump screen bolt and nuts.
  4. Remove the oil pump screen with O-ring seal.
  5. Remove the O-ring seal from the pump screen.
  6. Discard the O-ring seal.
    7. Fig 2: View Of Crankshaft Oil Deflector & Nuts
    GM683798Courtesy of GENERAL MOTORS CORP.
  7. Remove the remaining crankshaft oil deflector nuts.
  8. Remove the crankshaft oil deflector.
    9. Fig 3: View Of Oil Pump & Bolt
    GM64281Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not allow dirt or debris to enter the oil pump assembly, cap end as necessary.
  9. Remove the oil pump bolts.
  10. Remove the oil pump.
  11. Clean and inspect the oil pump. Refer to Oil Pump Cleaning and Inspection .
scientia non olet · About LEMON Manuals