LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Oil Level Indicator and Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Level Indicator
    GM1236365Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil level indicator from the tube.
    2. Fig 2: View Of Oil Level Indicator Tube & Bolt
    GM1236364Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil level indicator tube bolt.
  3. Remove the oil level indicator tube from the engine block.
    4. IMPORTANT: The O-ring seal may be reused if not cut or damaged.
  4. Inspect the O-ring seal for cuts or damage.
  5. Remove the O-ring seal from the tube (if required).
scientia non olet · About LEMON Manuals