LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Rear Cover Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pan-To-Rear Cover Bolts
    GM680413Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine flywheel. Refer to Engine Flywheel Replacement .
  2. Remove the oil pan-to-rear cover bolts (1).
    3. Fig 2: View Of Rear Cover, Bolts & Gasket
    GM64282Courtesy of GENERAL MOTORS CORP.
  3. Remove the rear cover bolts.
  4. Remove the rear cover and gasket.
  5. Discard the rear cover gasket.
  6. Clean and inspect the rear cover. Refer to Crankshaft Rear Oil Seal Housing Cleaning and Inspection .
scientia non olet · About LEMON Manuals