LEMON Manuals: Even more car manuals for everyone
Home >> Hummer >> 2008 >> H2 4D Utility Wagon >> Repair and Diagnosis >> External Pages >> Different car >> Section 62 (Engine Mechanical) >> Repair Instructions >> On-Vehicle Repair Instructions >> Engine Oil Level Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of RH Side Engine Electrical Connectors
    GM662991Courtesy of GENERAL MOTORS CORP.
  1. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement .
  2. Disconnect the oil level sensor electrical connector (6).
    3. Fig 2: View Of Oil Level Sensor
    GM260123Courtesy of GENERAL MOTORS CORP.
  3. Remove the oil level sensor from the oil pan.
scientia non olet · About LEMON Manuals